Posted by [IP Address: 193.132.64.161] 'Rev Stephen Mooney' on July 25, 2001 at 04:18:04 EST:
In Reply to: About Work Flow Status posted by [IP Address: 193.132.64.161] 'Matthew Lee' on July 24, 2001 at 08:17:43 EST:
Matthew wrote:
: Some Work Item has the status of Executed, but not completed.
: But why the system not completed it when the user execute the work item.
_________________
It may be the case that the user has not completed the task properly.
Workitems can be executed (e.g. a workitem to create an invoice), but, unless the user actually creates an invoice, the status will not change.
OK, but let's assume that the user has completed the task correctly; the problem would most likely be that a termination event hasn't been raised correctly for that workitem.
Check the event log (transaction SWEL - remember to activate first!) for termination events - you should see an error message if there has been a problem (double click on pertinent line).
If no termination event is raised, check your event bindings (through PFTC), also check whether any short-dumps are occuring (ST22); failing that, check that the RFC destination user (WF-BATCH) has been configured correctly in transaction SWU3.
Let me know how you get on.
Every Blessing,
The Reverend Stephen Mooney