EVENT NOT FIRED!

[ Follow Ups ] [ Post Followup ] [ Message Board ]

Posted by [IP Address: 61.170.136.157] 'POOR man' on July 18, 2001 at 23:03:04 EST:

1.set up a change document ZMARA, only one table MARA in it, then genarate it
2.set up a subtype ZBUS1001 and create a event 'mara_change'
3.run SWED and add one entry
4.run SWEC add one entry

but when i create a material, event 'mara_change' no fired!
why?

Follow Ups:

Re: EVENT NOT FIRED! Rev Stephen Mooney 06:01:13 7/19/01 EST (3)
- BUT....... POOR man 06:51:08 7/19/01 EST (2)
  - Re: BUT....... Rev Stephen Mooney 09:02:28 7/19/01 EST (1)
    - THANKS POOR man 00:51:13 7/20/01 EST (0)

Post a Followup

Name:
E-Mail:
Subject:
Message: : 1.set up a change document ZMARA, only one table MARA in it, then genarate it : 2.set up a subtype ZBUS1001 and create a event 'mara_change' : 3.run SWED and add one entry : 4.run SWEC add one entry : : but when i create a material, event 'mara_change' no fired! : why?