PO header condition

[helloSAPworld]

if my PO has 100 items and each item have this condition Z001 which is in percentage but zero rate.(not able to maintain the % rate in MEK2 as only after PO was created then we know the % rate and sometimes the % rate will differs as well)

is it possible that i can just enter the % rate in the header level and it will populate the % rate in each line because it will be very time consuming if i were to enter the rate in the 100 items lines.
thanks.

[Ha Tran]

Hi,

For header condition type, any value entry will be applicable to the entire PO (i.e. for all PO line items).

Cheers,
HT

[helloSAPworld]

Hi,

For header condition type, any value entry will be applicable to the entire PO (i.e. for all PO line items).

Cheers,
HT

so it's not possible for % entry?

[Ha Tran]

Hi,

What do you mean ''percentage''?. When you define your condition type via M/06 transaction, you can set your condition type up as 'fixed amount' or 'percentage'. Does it answer your additional inquiry?

Cheers,
HT

[helloSAPworld]

hi HT,

thanks.