PM Task List Sampling Procedure drop down List

[thecanadian]

Hi Gurus,

In PM task list, in the inspection characteristics overview screen, if there is Master Inspection Characteristics & Method entered, the sampling procedure drop down list varies. How this filtration is done(what combination of settings-config does this filtration).

Thanks,
Kingsley

[farwamalik]

Hi,

Sampling procedure drop down list for any MIC depends on three things,

1. Control indicator of MIC
2. Inspection point in header of Task list
3. Valuation mode of Sampling procedure

E.g if the MIC is QN and has the Limits indicator (LSL/UPL) then u can use valuation mode "Mean valuation"
if the MIC is QL and has the Catalogue indicator then u can use "valuation acc. to characteristics attribute"
Valuation Mode " Manual" can be used for both QL & QN characteristics for all of the scenerios eiher with limits & w/o limits
If ur task list header contains the Inspection points then u have to mark the respective inspection point indicator in sampling procedure otherwise u cant find the sampling procedure

for PM Task list "Plant maintenace" indicator is used because in header of the task list "inspection point for equipment" have to be defined.