Operation falls off Capacity Planning Table

Logistics : PP

Moderators: Snowy, thx4allthefish, Ha Tran

Post Reply
PortlandRainmaker
Posts: 1
Joined: Tue Jan 12, 2010 12:03 pm

Operation falls off Capacity Planning Table

Post by PortlandRainmaker » Tue Jan 12, 2010 12:15 pm

Whenever I do a partial confirmation on an operation that I have finite scheduled, it falls off the capacity planning table (CM25). How do I get this to stay on the board. I'm using CO19 or CO11N to confirm operations.

birdiemaker
Posts: 34
Joined: Tue Aug 08, 2006 9:59 am

Re: Operation falls off Capacity Planning Table

Post by birdiemaker » Tue Jan 19, 2010 9:40 am

Take a look at the work center the operation is associated with. What is your method of capacity reduction? (Look on the Capacities tab on the right hand side under "Control CapacityReduction") Most often you see formula related, but it is possible that you are reducing the remaining capacity requirement completely after only a partial confirmation, therefore it would fall off the board.

Post Reply