Page 1 of 1

Setting of WBS status to closed

Posted: Mon Jul 13, 2009 1:40 am
by MabelChan
Hello,

We are trying to set the status of a WBS to closed. When we do so, an error message was displayed: "Incoming order value not settled in full". We tried to run result analysis and then settlement again, but nothing was settled and the WBS still cannot be closed. Has anyone encountered this before and how can we resolve this? Thanks.

Best regards,
Mabel

Re: Setting of WBS status to closed

Posted: Thu Jul 16, 2009 4:55 am
by greed
Result analysis it's not same as Incoming Orders.
See settlement rule on WBS-element and settle it in CJA2.

Re: Setting of WBS status to closed

Posted: Thu Aug 13, 2009 4:02 am
by Sachu
Well, I think you need to have a distribution rule to settle Incoming orders to the profitability segment. If you already do, then make the settlement type to full and run settlement.