Page 1 of 1

Replace counter - IK11

PostPosted: Wed Feb 11, 2015 8:20 am
by Windux
To signal in SAP ECC that a counter was replaced uses to IK11 transaction and the path Edit / Replace Counter.

My system is allowing me to enter a value greater than zero. This value is not incremented to previous measurements.

It is a mistake? Unable to find any possible configuration. Someone has corrected this error? User Exit?

Tks, Windux :?:

Re: Replace counter - IK11

PostPosted: Wed Feb 11, 2015 10:32 pm
by didier
standard behaviour , I'm afraid. And quite logic, as your new counter is not necessary installed with a counter value of 0.

as this is a counter replacement, the value is not added to the total counter value .

Didier