Page 1 of 1

Selection field groups. How can they be used? [Resolved]

PostPosted: Thu Jun 29, 2017 2:51 am
by DrSidewalk
Ideally I would like to use a selection field group, but I have several questions around these.

1). Can they be used for anythhing OTHER than a change of Material type, specific plant, or based on a user authorisation?.

2). Can these field groupos be used to cover fields across multiple tabs for MM02?

Ideally I would like to use a select field group based on an outside value set in a table. Would that be possible?.
For some materials they are maintain outside of SAP and then ent to AP to store. Therefore around 20 fields should nt be edited in MM02 and instead this editing should take place in the source system. I therefore need to set these fields (across multiple tabs) to read/only if they are one of these remote manitained materials.


Dr Sidewalk