Page 1 of 1

Cannot change

PostPosted: Mon May 22, 2017 7:20 am
by olatornblom
Hello

In the material master for a material, using transaction MM02 to change the conversion factor for an alternative unit of measure.

Situation is:

1 ACT <-> 1 ACT
25.146 KM <-> 15.625 ACT
1 EA <-> 1 ACT
1 ACT <-> 1 Mile

Trying to change the "Denominator for conversion to base units of measure" from 25.146 KM per 15.625 ACT to 1 to 1....but then I receive an error message:

"Alternative units of measure have been checked and corrected" (M3028).

And now the conversion factor table look likes this:

1 ACT <-> 1 ACT
1 KM <-> 1 ACT
1 EA <-> 1 ACT
15.625 Mile <-> 25.146 ACT

All I want to do is to get the 1 to 1 relationship between the KM and ACT...and at the same time 1 to 1 between Miles and ACT...is this possible to achieve somehow? Not sure if I am doing something wrong here?

BR,
OT

Re: Cannot change

PostPosted: Tue May 30, 2017 8:10 am
by Frank Lai
Well no, you cannot have 1 ACT = 1 KM and 1 ACT = 1 Mile at the same time. In effect you are implying to SAP the 1 mile = 1KM. Clearly SAP is not going to like that

Frank