Page 1 of 1

Automatic Usage Decision after results recording

Posted: Thu Oct 18, 2018 5:17 am
by PWNeiss
Hi Gurus,
was anybody already working with Auto-UD directly after Results recording?
I made all settings on client level, on plant level and maintained the event type linkage for BUS2045: nothing happened, no usage decision was created for the given Inspection Type.
I assume the Error is in event type linkage. Does anybody know the correct settings for the linkage, especially the receiver Type for BUS2045 and Event RESULTRECORDED?

Thank you for your ideas

Regards

Paul