Page 1 of 1

Inspection Point Function Module

PostPosted: Wed Mar 25, 2015 10:59 am
by aat99aat99
hi

Has anyone seen this error before:

The import params for function module Z_QM_QAPP_CUST_IP_CHECK_CAL differ from the example module
Message no. QT113

Diagnosis
You specified a function module whose interface does not correspond with the interface of the sample function module QAPP_CUST_IP_CHECK.

Procedure
Check the function module Z_QM_QAPP_CUST_IP_CHECK_CAL, and compare the import parameters with those of the sample function module QAPP_CUST_IP_CHECK.



We've checked the import parameters and they match so we can't see what is incorrect. Can't see anything on SCN either.

Thanks for any help !

Cheers

Al

Re: Inspection Point Function Module

PostPosted: Wed Mar 25, 2015 12:11 pm
by Gothmog
Could you post the parameters of your function module?

Re: Inspection Point Function Module

PostPosted: Wed Mar 25, 2015 12:26 pm
by aat99aat99
Hi

These are the parameters:

Import

I_QALS TYPE QALS Inspection lot record
I_QAPP TYPE QAPP Inspection point
I_VORGLFNR TYPE QAPO-VORGLFNR Current Node Number from Order Counter APLZL

Tables

T_QAPP LIKE QAPP Inspection point
T_QAPO LIKE QAPO Inspection operation records

Re: Inspection Point Function Module

PostPosted: Thu Mar 26, 2015 3:55 am
by Gothmog
The name and type are not sufficient - the program also compares how it's typed (LIKE or TYPE...), if it's optional, passed by value or reference...
I think your problem is that you should use LIKE and not TYPE for I_QALS, I_QAPP and I_VORGLFNR.

Re: Inspection Point Function Module - Fixed

PostPosted: Thu Mar 26, 2015 6:17 am
by aat99aat99
Hi Gothmog

Yes it was indeed what you suggested. Thanks for your help.

cheers

Al