This website is not affiliated with, sponsored by, or approved by SAP AG.

Inspection Point tab as default in UD screen

Logistics QM

Moderators: Snowy, thx4allthefish, Ha Tran

Inspection Point tab as default in UD screen

Postby Evguenia » Thu Feb 21, 2013 8:02 am

When you go to make UD for a lot in QA12 there are 3 tabs displayed: Defects, Characteristics and Inspection Points (if material is set up to have inspection points)

The default tab is usually Characteristics.

Is there any way of changing that? Can I set up, for example Inspection Points tab as default instead?

Thanks!
Evguenia
 
Posts: 2
Joined: Thu Feb 21, 2013 6:41 am

Re: Inspection Point tab as default in UD screen

Postby ask » Thu Feb 21, 2013 11:21 am

Don't believe so..And why?
There is no static default..Based on the condition of the underlying defects and rejected characteistics or inspection points, it prompts the user to look at that tab first..
Anand
ask
 
Posts: 765
Joined: Thu Dec 12, 2002 9:14 am
Location: California


Return to Logistics QM

Who is online

Users browsing this forum: No registered users and 1 guest





loading...


This website is not affiliated with, sponsored by, or approved by SAP AG.