This website is not affiliated with, sponsored by, or approved by SAP AG.

Target value in RR Char overview

Logistics QM

Moderators: Snowy, thx4allthefish, Ha Tran

Target value in RR Char overview

Postby Trygve » Tue Feb 12, 2013 5:22 am

Hi

We're doing som IPC where we want the target value to be visible during Result recording. This is to make production more focused on reaching the target and not only being within limits.

If I go to the detailes selection where I only see one MIC at the time the target is visible along with the limits, but in the overview I'm not able to make the target value visible, only the limits.

Since production is supposed to maintain several results at the same time going into the single characteristic view maintaining one at the time is a bit awkward and more time consuming, thus we'd prefere to use the overview.

Have I overlooked a simple solution or do we have to do some modification to be able to see the target value in the overview ?

We're using ECC 6.0 EHP 3
Regards
Trygve
Trygve
 
Posts: 966
Joined: Mon Oct 21, 2002 1:53 am
Location: Norway

Re: Target value in RR Char overview

Postby Craig » Tue Feb 26, 2013 10:37 am

If you are not using them already you could copy the target value into one of the three user fields. You cold use an LSMW to update your existing mics or plans.

Craig
Craig
 
Posts: 5505
Joined: Sun Oct 20, 2002 11:07 pm
Location: Heading back to the Milky Way...

Re: Target value in RR Char overview

Postby Trygve » Wed Feb 27, 2013 4:02 am

Thanks Craig.

I'm not using any of those fields, so I'll look into it. :)
Regards
Trygve
Trygve
 
Posts: 966
Joined: Mon Oct 21, 2002 1:53 am
Location: Norway


Return to Logistics QM

Who is online

Users browsing this forum: No registered users and 4 guests





This website is not affiliated with, sponsored by, or approved by SAP AG.