Inspection Points - Forcing the Acc/Rej Indicator

[goodolboy]

ECC 6.0

I am rolling out some inspection plans with inspection points and am having an issue with them. Due to the fact they do not have a sampling procedure on the MIC every time I enter a sample value into gLIMS it asks me to “Set either the acceptance or the rejection indicator’. This option pops up in native SAP but not in our gLIMS tools ( Custom Webdynpro front end ). Is there a way to have this setting be automatically set, or bypassed like the MIC’s with the Sampling Procedure selected in there profile????

Thanks,
Sean

[Craig]

I'm a little confused. You say that in glims it prompts you to set the indicator. In the next sentence you say its is not in your glims tools. Taht is confusing to me.

Glims must pass the characteristic's valuation back to SAP.

So I'm not sure I am getting the question.

Craig