Valuation in Result Recording

[andihermawan]

Dear Sap Fans,
Please your help.
When entry the result recording, Valuation in result recording is empty. How to setting the valuation, automatically set to accepted or rejected.
Thanks very much and waiting your solution.

Regard,

andi

[Craig]

Typically, you would assign a sampling procedure. In the sampling procedure you select the valuation mode which tells the system how to valuate the characteristics. Most people use a valution of either mean value in tolerance or attribute code.

Craig

[andihermawan]

SAP Fans,
Craig, thank very much for your respond.
I have try to create the sample procedure.
If I fill the sample Qty=2, Valuation in result recording automatically update and I fill the sample Qty=1, Valuation in result recording not update.
Any customizing setting for valuation?

Thanks and regards,

[Rienk]

Hi,

Did you check the user settings in QE51N? Tab: Recording configuration, eg. aut close when saving.

Rienk

[Craig]

I'm not sure what you mean by this:

If I fill the sample Qty=2, Valuation in result recording automatically update and I fill the sample Qty=1, Valuation in result recording not update.

It sounds like when you put in the value of 2 for... what? units inspected? that it automatically valuated but for a 1 it did not.

If that is the case, it sounds like the system worked and that whatever you set up is looking for you to inspect 2 items. When you only record that you did 1, it won't valuate because it is expecting 2. When you enter 2, it does, because that is what it was expecting.

Craig