This website is not affiliated with, sponsored by, or approved by SAP AG.

calling function modules

Logistics QM

Moderators: Snowy, thx4allthefish, Ha Tran

calling function modules

Postby ceulemaj » Wed Jun 15, 2011 5:25 am

Hello ,


I aim not familar with function modules in calculation characteristics , but I think that for every function we will use we need to create a new function . In th efunction modules I do not see input parameters . Is this correct?

We are working with PMtask list , and a lot of inspection characteristics and even more complex calculations (Gas and oil business).

Thanks


Jan
ceulemaj
 
Posts: 135
Joined: Mon Mar 08, 2010 5:59 am

Re: calling function modules

Postby Craig » Thu Jun 16, 2011 5:55 am

You only need to create a new function module if none of the exisitng formula parameters allow you to create the formula you want for your calculated characteristic.

This is a list of the standard parameters allowed:
A0 Measured value for single unit
B0 Arith. mean of measur. values for sample
B1 No. of valid measured values for sample
B2 Share of defective units for sample
B3 No. of defects observed in sample
B4 No. of defective units in sample
B8 Variance of valid meas. values in sample
B9 Minimum valid meas. value in sample
BA Maximum valid meas. value in sample
C0 Arith. mean of measured values for char.
C1 No. of valid measured values for char.
C2 Share of defective units in char.
C3 No. of defects observed in char.
C4 No. of defective units for char.
C5 Upper limit of tolerance range
C6 Lower limit of tolerance range
C7 Target value of characteristic
C8 Variance of valid meas. values for char.
C9 Minimum valid meas. value for char.
CA Maximum valid meas. value for char.
D0 Function module test
Craig
 
Posts: 5505
Joined: Sun Oct 20, 2002 11:07 pm
Location: Heading back to the Milky Way...

Re: calling function modules

Postby socal » Tue Mar 19, 2013 6:04 pm

where do I enter my function module?
and how do I pass the parameters?
SoCal :idea:
socal
 
Posts: 233
Joined: Thu Oct 31, 2002 7:43 pm
Location: SoCal

Re: calling function modules

Postby Craig » Tue Mar 26, 2013 8:02 am

Quality Management-->Quality Inspection-->Results Recording-->Define Parameters for Calculated Characteristics
Craig
 
Posts: 5505
Joined: Sun Oct 20, 2002 11:07 pm
Location: Heading back to the Milky Way...


Return to Logistics QM

Who is online

Users browsing this forum: No registered users and 3 guests





loading...


This website is not affiliated with, sponsored by, or approved by SAP AG.