This website is not affiliated with, sponsored by, or approved by SAP AG.

Force inspection completion

Logistics QM

Moderators: Snowy, thx4allthefish, Ha Tran

Force inspection completion

Postby Ai Lim » Sun Sep 06, 2009 12:04 pm

Dear Experts,

I've already execute QE51N (inspected quantity and result are inputted) for one qualitative characteristic.
When I want to do QA11, there is message as below:
"Reqd characteristics still open! Do you want to force inspection completion?"
Why does the message appeared? What is the impact for this message? Can I eliminate this message?

Kindly need your advice for this.

Thank you in advance.
Best Regards,
Ai Lim
Ai Lim
 
Posts: 78
Joined: Mon Jan 21, 2008 9:30 pm

Re: Force inspection completion

Postby chalasani » Mon Sep 07, 2009 5:32 am

Hi,

After the results are recorded you have to evaluate the result and close the characteristic,

if above procedure is followed you will not get the message in QA11.It is only an information message that the results were not evaluated.

CSN
chalasani
 
Posts: 2
Joined: Tue Jun 12, 2007 6:35 am

Re: Force inspection completion

Postby AKelly » Wed Jun 12, 2013 2:10 pm

I'm having the same issue when results are recorded via an IDI interface (QIRF_GET_ALL_DATA_VALUES2). The result is logged, status of MIC is "5" but system still shows it as open. Any ideas??
AKelly
 
Posts: 20
Joined: Wed Jun 12, 2013 1:55 pm

Re: Force inspection completion

Postby AKelly » Wed Sep 04, 2013 11:08 am

Just following up. Passing an 'X' for field KZLPROBE marks that characteristic as "closed" and no further chars are expected*(see note) so the short term characteristic flag is set to 0. *Note: just b/c the KZLPROBE is passed, you can STILL create additional inspection points and record results.
AKelly
 
Posts: 20
Joined: Wed Jun 12, 2013 1:55 pm


Return to Logistics QM

Who is online

Users browsing this forum: No registered users and 3 guests





loading...


This website is not affiliated with, sponsored by, or approved by SAP AG.