This website is not affiliated with, sponsored by, or approved by SAP AG.

Tolerance limits not copied from plan to inspection lot

Logistics QM

Moderators: Snowy, thx4allthefish, Ha Tran

Tolerance limits not copied from plan to inspection lot

Postby driri » Wed Oct 30, 2002 3:32 am

I created an inspection characteristic that is a complete copy model.
It is assigned to an inspection plan, where I changed the tol. limits.
When an inspection lot is created, the tol. limits from the insp. char. are copied into the inspection lot, rather than the tol.limits from the plan!
Please advise
driri
 
Posts: 74
Joined: Mon Oct 21, 2002 4:59 am
Location: The Netherlands

Postby QM-Dude » Wed Oct 30, 2002 6:18 am

Hi,

what you described is very strange and should not happen. For plan characteristics the limits from the unlocked characteristic will be used. Please check the valid date of the inspection plan. Maybe you create an inspection lot with an older version of the plan. If this does not help check the SAP table QAMV àbout the dates and times or the characteristic preferences assigned to the inspection lot.

Best regards
QM-Dude
QM-Dude
 
Posts: 277
Joined: Tue Oct 29, 2002 3:39 am
Location: Germany

Postby driri » Wed Oct 30, 2002 7:09 am

Thanks for your reply dude!
I discovered that version management had been turned on accidently for about a day. That caused for the "wrong" spec upload!
driri
 
Posts: 74
Joined: Mon Oct 21, 2002 4:59 am
Location: The Netherlands


Return to Logistics QM

Who is online

Users browsing this forum: No registered users and 6 guests





loading...


This website is not affiliated with, sponsored by, or approved by SAP AG.