This website is not affiliated with, sponsored by, or approved by SAP AG.

Teklogix and document number range

Third Party products such as GuiXT, BMC Patrol, Vertex, Ixos etc...

Moderators: Snowy, thx4allthefish

Teklogix and document number range

Postby SL on Thu Oct 14, 2004 11:12 am

Hi, I am looking to see if anyone else has had an issue with using the TekRF solution and document number size. The TekRF system has been working well but we recently had to change our GR material document number range from using 8 of the 10 allowed digits to using all 10 digits( no two leading zeros anymore ). The TekRF system didn't like this and couldn't do GR anymore. Has anyone else had this happen to them? Thanks in advance.

SL
 
Posts: 43
Joined: Wed Apr 02, 2003 4:43 pm
Location: AL,USA

Postby elmanu on Fri Oct 22, 2004 5:32 am

I used TEKRF in different project, and we used 10 digits number ranges without any problems.
You should check the transaction development in TekRF, most of the times, the problems comes from the Tek development.
elmanu
 
Posts: 529
Joined: Wed Nov 06, 2002 4:25 am
Location: in front of the screen

Postby Guest on Fri Oct 22, 2004 8:49 am

Thanks. The TekRF project manager says that the 8 digit number range was agreed upon during testing yet it isn't defined in the data definition for the project. I wasn't involved in the design of the project but I doubt that is the case since our SAP consultant knows that number is 10 digits.
Guest
 


Return to Third Party Products

Who is online

Users browsing this forum: No registered users and 1 guest



This website is not affiliated with, sponsored by, or approved by SAP AG.