an empty table line in the main window

Development SAPscript/ Smartforms

Moderators: Snowy, thx4allthefish, YuriT, Gothmog

Post Reply
kkktank
Posts: 13
Joined: Mon May 26, 2008 8:29 am

an empty table line in the main window

Post by kkktank » Sun Oct 26, 2008 11:12 am

in table, main window.
print a large internal table in a smartforms.
In some pages, there would be an empty table line, always the last line in this window. There is no data lost (I checked the data printed out and the data in the internal table), but just only an empty line was printed.
When I asked my collegue, he said he also encountered this problem and solved it with adjusting the height of the main window.

Have you encountered this and How did solve it? (An upload of image may make it clear)

BradB
Posts: 685
Joined: Wed Mar 22, 2006 10:27 am
Location: Standing right behind you

Re: an empty table line in the main window

Post by BradB » Mon Oct 27, 2008 8:29 am

Are you sure that it's an empty table line? More likely, it's the fact that the remaining window height is slightly less than the line height and spacing, so a new page was triggered. If all of your lines in the main window are the same height and have the same line spacing, then it's easy to calculate what the height of the main window should be. If not, then it's a bit trickier. There are some additional page protection options with NW 7.0; you may be able to take advantage of those if you have that version.
Ironman Triathlete and SAP Dev/Config Expert
(which is harder?)

Post Reply