Page 1 of 1

Customer Partner Functions - Data Load issue

Posted: Thu Mar 17, 2011 6:43 am
by Gladiator
Hello,

As part of Main Customer loads (Soldd-to), we loaded all the Customers. Partner Functions - pointing to same Customer Number - were created for all the Customers.
Our second step was to create Partners for the sold-to. When we load Partners, they are being 'added' to the existing default Partners but not replacing.

We used the standard SAP RFBIDE00 in LSMW for this.

Apart from the 'recording' method, is there any way we can achieve this?

Best Regards,

Re: Customer Partner Functions - Data Load issue

Posted: Tue Mar 29, 2011 9:17 am
by Squarebear
It's been a while since I did this so don't shoot me down. :oops:

What effect might the following steps have:

Run 1. XD01 - excluding partner functions

Run 2. XD02 - including just partner functions.

Re: Customer Partner Functions - Data Load issue

Posted: Wed Mar 30, 2011 7:30 am
by SHS
If I recall correctly, you can specify in customizing which partner functions should be created as default (using the same customer number as the customer that is created).

Perhaps the easiest solution is to change these customizing settings, if you are not planning on using any of these default partners.