Page 1 of 1

Decompression Error (receiving)

PostPosted: Tue Jul 18, 2017 3:10 pm
by kwindle
We have recently upgraded to ECC6 Enhancement pack 5. At the same time, we implemented Unicode (pardon if my terminology is not exact. I'm an MM guy, not a basis guy). Most of our users are on GUI 730 patch level 15. We have one program (Z program) that keeps popping up this error "PRD: Decompression error (receiving) - Program will be terminated". It's only this program and only happening for most users periodically throughout the day. When it happens, it knocks the user completely out of SAP. There are a handful of users that have never experienced this error. We have tried 740 GUI, additional RAM, "optimizing" the program, trace using ST12, and reinstalling SAP with no luck. Prior to upgrade, this program worked flawlessly. We have run out of ideas and solutions for this error are limited. I have opened a ticket with SAP, but they have yet to find a solution. Any new suggestions would be greatly appreciated.

Re: Decompression Error (receiving)

PostPosted: Wed Jul 26, 2017 9:24 am
by Boss
Hi kwindle,
Maybe problem in Unicode Conversion procedure? Verify Logs.
Is your Z report using Pooled table? If yes try run SDBI_POOL_CHECK report.
Regs
Boss

Re: Decompression Error (receiving)

PostPosted: Fri Jul 28, 2017 1:35 pm
by kwindle
Thanks for your reply Boss. Our basis team and programmers are looking into your suggestions. I will report back as soon as the results are in.
Your response is greatly appreciated.