Time Operation

[pkdave99]

We're on ECC6.

To create a customer operation we did the following:

1. Add the operation "opxshdy" in the include "RPTMOZ00"
2. Create the time management operation "xshdy" ( PE04 )
3. Activate all ( PE04 )
4. Added the operation

When we run the time evaluation we get a runtime abend "PERFORM_INDEX_TOO_LARGE". It abended at the step in include "RPTOIP00". In the table T52A0 we find the entry "xshdy" with internal number "4D". But we fail to find the operation "opxshdy" in the include "RPTOIP00". The last internal number in "RPTOIP00" is "4C".

Did we miss any step(s)?

[robinetteh]

DId you elect the model for the operation and the type of velues the operation will use?
If this is not done, then you might have some problems. I am assuming that you added code to the include RPTMOZ00.