Page 1 of 1

Cost collector - How to modify the LOT SIZE?

PostPosted: Fri Oct 03, 2014 1:52 pm
by sgmsouza
I have a question about how to modify the lot size of a material.

When building a cost collector, use the KKF6 transaction.

Question: if after the creation of cost collector I have identified that the lot size is incorrect (example: 1 piece), there is a way to change it after it has been created in the transaction KKF6? (example: change from: 1 piece to: 100 pieces)?
How to do this procedure?

Thank you very much.